Your Documents
SOP-07 · Lockout / Tagout v3
Energy isolation & tagging
WI-12 · Press Brake Die Setup v2
Tooling, torque & alignment
AS/NZS 4024.1602 · Machine Guarding
Guard interlocks
QM-2026 · Quality Manual v6
Inspection & records
0 documents ·
0 sections searchable
Campbellfield plant · last updated 2 days ago
Ask the shop-floor copilot
Answers come straight from your approved SOPs & work instructions — with the source shown.
Torque for the M20 die-clamp bolts?
Lockout steps before clearing a jam?
Guard interlock reset rule?
What torque do the M20 die-clamp bolts on the press brake need?
Searching your documents…
Sources
WI-12 · Press Brake Die Setup v2 · §3.1
“M20 die-clamp bolts shall be torqued to 280 Nm in a diagonal pattern across two passes — 50%, then 100% — using a calibrated torque wrench.”
AS/NZS 4024.1602 · Interlocking devices for guards
“Tooling must be verified secure before guard interlocks are reset and the machine is returned to service.”
Drawn straight from 2 of your documents — check it against the open SOP before you act.
Your call before you act:
What pressure should the coolant pump run at on the new CNC cell?
Searching your documents…
⚠️ Not in your approved documents
The new CNC cell’s commissioning manual hasn’t been added yet. No answer will be given here rather than risk a guessed coolant pressure — the wrong setting could damage the spindle. Confirm the figure with a person before running the cell.
Ask a question about your SOPs…
↑